Thursday, June 2, 2011

Choices



Wood working often involves choices and decisions that the end user is never aware of. When choosing boards for a project I always keep in mind how they will be used. In the case of the project at had the glued up boards will be carved and the panel will not be used as part of a traditional frame and panel assembly. Because I will be carving the panel I need the direction of the grain runout in both boards to be the same so I can carve the seam. In real terms what this means is that I cannot turn the boards end for end or flip them over in any orientation I like, but rather I have to pay attention to the way the grain is running in the edge of the board as well as the face that is visible.

My best option for the boards I had on hand left me with one board having a large crack on one face. The choice I had to make about that crack was whether to cut it out and have another glue seam in the face or to use that board with the crack oriented on the back. The crack was almost 1//32" wide at its widest but I had no way of knowing how deep it went. It was not visible from the front but there are parts of the front that will have 1" removed in the carving process.

I opted to use the board and to stabilize the cracks from the back with butterflies. Butterflies are a traditional way of stabilizing a crack, to keep it from growing in the future as the board expands and contracts with the changes in seasonal humidity. I usually make my butterflies the full thickness of the board to give them as much strength as possible but in this case I could only go 1" deep or I would risk carving into them from the front. Luck was on my side because when I routed out the recess for the butterflies the crack was only 3/4" deep at the deepest and much less for most of its length.

The butterflies are oriented so the crack is at the narrowest part of the butterfly so that if the board tries to open up along the crack the butterfly acts like two wedge shaped anchors to keep it where it is. For this to work the wood used to for the butterfly has to be strong and the grain should be oriented with the long grain running along the length of the butterfly. I could have used any hard wood for the butterflies or even the same wood as the panel. I chose walnut because it has interlocking grain which means it won’t split as I hammer it into place. I also happen to have a lifetime supply of walnut due to my access to a defunct orchard.

It has become very fashionable to intentionally use boards with large cracks in them when making custom furniture. It is a great way of using an other wise un-usable piece of wood as well as showing that a human hand made the object rather than a machine in a factory. In this instance this is the back of a headboard, it will be against a wall and never be seen.

Robin


No comments:

Post a Comment